![]() Submerge all parts (cap, straw, gasket) in warm, soapy water for up to 2 hours.Disassemble straw and gasket(s) as mentioned above.The flat side of the gasket goes against the cap, blades out, larger blade on top. Look closely at the gasket, you’ll notice there are two “blades,” one stands out farther than the other. Re-Install: ensure all parts are dry before reinstalling and storing.Remove the circular cap gasket and place in the dishwasher’s utensil compartment, then place cap on the top rack of the dishwasher (with mouthpiece flipped open).For more thorough cleaning, use a small cleaning brush. Remove the straw and place in the dishwasher’s utensil compartment.It also includes the sturdy TripleHaul Handle for easy hauling. The best way to drink on the move? The Straw Cap - a one-handed flipping operation. RAMBLER BOTTLE STRAW CAP CLEANING INSTRUCTIONS For a secure fit, smooth out any twists or kinks. Reminder: Install gaskets with flat side facing upward and the gasket grooves facing downwards toward the bottom of the cap.Ensure all parts are dry before reinstalling and storing. Install gaskets with flat side facing upward and the gasket grooves facing downwards toward the bottom of the cap.Remove both gaskets below and above the threads and place in the dishwasher’s utensil compartment, then place cap on the top rack of the dishwasher.It’s the foolproof way to transport your hydration from Point A to Point B without spilling a drop. This is our classic cap, over-engineered to be leakproof, easy-to-carry, and tough as hell. Travel Mug and is not compatible with other YETI drinkware. ![]() Please note: This lid is not to be used with carbonated beverages.Place all parts in dishwasher’s utensil compartment.Make sure slit is facing down on the lid when reinstalling. Remove gasket from the lid using two fingers to pinch it on either side.Slip off the rubber sleeve covering the lower magnet.Half twist the lower magnet horizontally to remove.Even better, they’re all dishwasher safe. For a deep cleaning, the gasket and magnets pop right off. Our twist-on, twist-off StrongHold lid is backed with dual-slider magnet technology to add a strong layer between your free-flowing drink and the outside world. Reminder: Larger blade around gasket should be above the smaller blade.Ensure all parts of the cap are dry before reinstalling and storing. Install the gaskets placing the larger blade around gasket above the smaller blade.Once removed, place all parts in the dishwasher’s utensil compartment. This should make the gasket lift up from its groove. Remove gasket from the tumbler lid by using two fingers to pinch it on either side.Pop the MagSlider off the tumbler lid and place in the dishwasher’s utensil compartment.For a deep cleaning, the gasket and MagSlider magnet pop right off. ![]() Its smooth-sliding mechanism slides shut to lock in wayward drops. Our splash- and shatter-resistant MagSlider Lid is unlike any other lid. Just grab a stainless steel cleaner at your local store. Our stainless steel rarely rusts, but if it does, polishing it up is simple.Two tablets recommended for drinkware over 30 ounces.Do not shake solution in the drinkware.Pour out solution and rinse thoroughly with water.Drop in one YETI Cleaning Tablet, let sit for five minutes.For coffee or tea stains that just won’t let up, opt for our deep-cleaning tablets. ![]() Don’t have a dishwasher? Hand washing them with mild dish soap will do just fine.
0 Comments
Leave a Reply. |